Technical Specification

Insulating Material: Polycarbonate
Rate Voltage: 110 & 220 VAC, 50HZ/60HZ
StorageTemperature: -15 degree to 60 degree

- Apply one unit of power saver to each phase.
- Device can be use in any countries that have an electricity supply of 110 to 130 VAC 60Hz or
220 to 240 VAC 50Hz.
- This device is not designed for heavy duty load or monthly consumption higher than 6000kwh.




Single-phase (Example: Apartment)



Plug in one unit of Power Saver into any independent
13Amp wall socket/Power Point (Prefer close to the main
distribution Box/Circuit Breaker)
For monthly electricity consumption from 350 to 1000kWH:
please use Model MS 188.
For monthly electricity consumption from 500 to 2000 kWH:
please use Model MS 388.
(*For consumption below 700kWH monthly, prefer to use
Model MS 188)




Three-phase (Example: Small Factory)


Plug in one unit of Power Saver to each phase(R,Y,B
phase or 1,2,3 phase) for all three phases, total 3 units are
needed. Please refer the installation to a qualified electrician
(To determine the power points of different phases).
For monthly electricity consumption from 750 to 2000kWH:
please apply 1 unit of Model 188 to each phase.
For Monthly electricity consumption from 1500 to 4500kWH:
please apply 1 unit of Model 388 to each phase.
For Monthly electricity consumption from 4500kWH to
10,000kWH, please apply 2 units of Model 388 to each phase.

Precaution

1. Plug this device into a wall socket/power point, not an extension lead or multiple socket.
2. Plug of the power cord should be firmly attached to socket, poor or loose contact must be avoided
when power is switch on.
3. As the device can store electrical charge, wait for 10 seconds after the electrial supply is switch off
before unplugging from socket