thank you for Mr.tan using our products

ELECTRIC CITY POWER SAVER (FEATURE)

90 Days Money Back Guarantee, No Question Ask Refund. + 2 Years Warranty

Here is a smart way to reduce your Electrical Consumption.
Just plug in our new Power Saver!!!

Power Saver is design using advance component
and technology to reduce the energy wastage caused by
motors, aircon, refrigerator, fish pump, lighting, computer, etc.

Ingeniously designed for easy use. Just plug into power outlet.

Suitable for houses, condominiums, apartments, shops,
restaurants, offices, small factories,etc

-Reduces your Electricity Consumption
-Improve power factor
-Reduce electrical overheating
-One unit will work for the whole house circuit
-Easy to use, Just plug into power outlet
-90 Days Money Back Guarantee*
-2 Years Warranty
-Suitable for houses, condominiums, apartments, shop lots,
-restaurants, offices, small factories, etc



Here is a smart way to reduce your electricity consumption. This new innovative device can
filter the supply voltage while improving the efficiency and power factor of your electricity
consumed.

This Device is able to store electricity for 5 to 10 seconds and release it for use doing
downside voltage. It can also improve safety by reducing the overheating of electrical wiring,
hence reducing the size of wiring an copper loss. (Precaution should be observed here, this
does not imply that attaching multiple units of the power saver will drastically reduce power
consumption in all cases. Please consult a trained electrician if advice is necessary.)

The amount of saving depends on few factors such as the type of electrical appliance use,
the amount of electrical use and location. Places near to shops, restaurants and light
industries where voltage supply is unstable and fluctuating will see higher savings.

In addition to extending the life span of appliance motor, this device also reduces the reactive
power generated by inductive loads. It helps the utility companies by eliminating interference
to the power supply. This Power Saver is tested in performance by PSB (Singapore).

A Test Result from PSB Corporation (Singapore) on a set of fluorescent tube.
View Test Report


1. The result obtained using a set of fluorescent tubes as the inductive load may not
be representative of any other type of loads.

2. Tests were performed to compare before and after installation of 'Mini Sun' Model
No. : MS 388 Power Saver and Stabilizer.

Technical Specification

Insulating Material: Polycarbonate
Rate Voltage: 110 & 220 VAC, 50HZ/60HZ
StorageTemperature: -15 degree to 60 degree

- Apply one unit of power saver to each phase.
- Device can be use in any countries that have an electricity supply of 110 to 130 VAC 60Hz or
220 to 240 VAC 50Hz.
- This device is not designed for heavy duty load or monthly consumption higher than 6000kwh.




Single-phase (Example: Apartment)



Plug in one unit of Power Saver into any independent
13Amp wall socket/Power Point (Prefer close to the main
distribution Box/Circuit Breaker)
For monthly electricity consumption from 350 to 1000kWH:
please use Model MS 188.
For monthly electricity consumption from 500 to 2000 kWH:
please use Model MS 388.
(*For consumption below 700kWH monthly, prefer to use
Model MS 188)




Three-phase (Example: Small Factory)


Plug in one unit of Power Saver to each phase(R,Y,B
phase or 1,2,3 phase) for all three phases, total 3 units are
needed. Please refer the installation to a qualified electrician
(To determine the power points of different phases).
For monthly electricity consumption from 750 to 2000kWH:
please apply 1 unit of Model 188 to each phase.
For Monthly electricity consumption from 1500 to 4500kWH:
please apply 1 unit of Model 388 to each phase.
For Monthly electricity consumption from 4500kWH to
10,000kWH, please apply 2 units of Model 388 to each phase.

Precaution

1. Plug this device into a wall socket/power point, not an extension lead or multiple socket.
2. Plug of the power cord should be firmly attached to socket, poor or loose contact must be avoided
when power is switch on.
3. As the device can store electrical charge, wait for 10 seconds after the electrial supply is switch off
before unplugging from socket

FAQ

Which model should i purchase ?
- Model MS 188 is suitable for monthly electricity consumption between 350 Kwh to
1000Kwh per month (Single Phase) and Model MS 388 is suitable for monthly
electricity consumption between 500 Kwh to 2000Kwh per month (Single Phase).
Can Mini Sun Power Saver be use in other countries with different voltage ?
- Yes. Mini Sun Power Saver can be use in any countries that have an electricity
supply of 110 - 130 VAC 60Hz or 220 - 240 VAC 50Hz.

Is there any prove to show us that this device can help us reduce our electrical
consumption ?
- Yes, we have a test report carried out by PSB Corporation(Singapore) on a set of
fluorescent tube.
View Test Report carried out by PSB Corporation (Singapore) - Click Here
Does Mini Sun Power Saver come with a warranty ?
- Yes. Each of our Mini Sun Power Saver is guaranteed for a Three(3) months on a
one-to-one exchange basis plus Two(2) years international warranty against
manufacturing defects and faulty materials from the date of purchase under normal
installation and use.
Where do we install this device?
- For Single phase, just plug the Mini Sun Power Saver into a 13-amps outlet after the
circuit breaker and switch on the unit.
Does Mini Sun Power Saver need any maintenance ?
- No. Mini Sun Power Saver have an estimated life span of around 5 years.
How many units must i buy ?
- For normal apartment/HDB (Single Phase) , you just need to purchase one unit.
One unit will work for the whole house circuit. As for three phase, you need three units
of Mini Sun Power Saver and Stabilizer. One unit to be plug into each phase.